BEMA / FOR YOUR PROJECT

Galvanised props for slab formwork

Choose each prop as part of the complete support arrangement. The required extension, load at that height and connections to heads, beams and the supporting surface all matter.

Discuss my project

Start with the complete assembly height

Room height alone does not determine the prop extension. Account for the formwork build-up, beams, heads and actual supporting level. Prepare the range of required heights, not just the highest point. Mark changes in height between slab areas on a sketch.

Include a design or material schedule if you have one. For existing components, state the manufacturer, identification and dimensions. A photograph helps identify a part, but does not establish its condition or the suitability of a combination.

Two actual models to compare

Both product descriptions specify pin adjustment in 10 cm increments and fine threaded adjustment. These figures help narrow the choice by dimensions. They do not imply identical load capacity or suitability for every formwork system.

Prop quantities cannot be based on floor area alone

The support design determines required capacity, spacing and quantities from the actual loads. For the chosen model, you need capacity data at the extension that will be used. A general maximum in a product listing or a series name is insufficient. A galvanised finish is not a load rating either.

Select compatible heads and other prop accessories at the same time. Check their connection to the beams and the manufacturer's instructions. Do not estimate contact dimensions or assembly stability from a similar photograph.

Frequently asked questions

Can a D40 automatically replace a B30?

No. Different extension ranges do not establish interchangeability. A substitution needs checking against the design, loads, geometry and accessories.

How many props do I need for my slab?

Floor area alone cannot reliably answer this. Send your design or schedule; quantities must suit the complete formwork arrangement.

What should I prepare for a quotation?

Required heights, component types and quantities from the design, accessories and the delivery location.

Compare the assembly and its components

Continue with construction props, formwork systems and our prop selection guide.

Galvanised props in the online shop Send your materials list

Call BEMARequest a quote